Professional Epoxy Repair Kit
310-R-B-PE-WHT01-Epoxy
$18.00
(In Stock)
 
Log In to add this item to your Wish List.
This professional grade kit is an easy to use epoxy repair kit which includes all the materials that are needed for most repairs on epoxy surfboards and SUPs. The repair kit includes: resin and hardener, fiberglass cloth, sandpaper mixing cup and sticks, and easy to follow instructions.

See instructions below.
Nose Width"
Mid Width"
Tail Width "
Thickness "
Volume (L)
Weight (lbs)
Fin System
Fin Setup
1. Prepare the ding by removing any debris or jagged fiberglass
2. Sand down the ding and surrounding area
3. Use Tuflite Ding Dough to fill hole and bring ding back to it’s original shape.
4. When dry, sand to even the repair area out if necessary
5. Cut fiberglass cloth slightly bigger than the ding. You can use two pieces of fiberglass for areas that need extra strength. Be sure to cover area around the ding. Tape off area if necessary.
6. Mix Epoxy resin 2 parts of “Part A” to 1 part of “Part B” in 2 oz cup provided. Mix thoroughly. Avoid stirring too quick to prevent air bubbles. Mix for roughly 1 minute.
7. Apply a thin layer of resin to the repair then add the 1st piece of fiberglass. Slowly saturate the cloth until it becomes clear then add the next layer if necessary. Again, make sure to slowly saturate fiberglass cloth.
8. Let dry. Should be completely dry in about 2 to 4 hours under normal weather conditions. Set up & cure time may vary due to weather and accuracy of mixing.
9. Once completely dry, use the sanding pad provided with the 2 grits of sand paper. Use the rough grit to remove any bumps and to shape the repair. Use the fine grit to blend the repair surface to the rest of the board. You can apply another “hot coat” of epoxy resin to conceal the texture of the fiberglass cloth if necessary.

Paint using Tuflite Touch Up or Spray Paint. Be sure to shake can thoroughly.


Skill Level
Max Weight lbs
Conditions